|
click
on image to enlarge
Includes
everything shown above:
- Register
cover
- Centering
bar
- J-hook
with wing-nut
$95.00
(USD)
Click
on the star to order
ASR-50-RD: Register duct kit
Caution:
by taking air from a positive pressure (forced-air heating/cooling
system), you are "pre-loading" the intake air.
This will give a higher air speed through the filter banks
in the Safe Cell. This higher air speed will reduce the
critical residence time of the air in the carbon adsorber
- affecting its ability to adsorb gases.
Please
contact us about this installation. Our engineer
will guide you through the proper testing techniques to
make this installation work properly. The contact information
is below.
|
|
This
kit allows you to easily connect the intake hose of the
Safe Cell to a household register duct used commonly in
residences and buildings with central force-air heating
and air conditioning.
It
is very simple to install:
- Place
the register cover (the large plastic piece) over the
register
- Insert
the J-hook through a central opening in the register
- Turn
it 90-degrees and pull up - seating it against on of the
bars in the register
- Place
the centering bar on top of the register cover and position
the end of the J-hook through the central hole in it
- Thread
the wing-nut onto the threaded end of the J-hook and hand
tighten
- Slip
fit the intake hose of the Safe Cell over the register
cover - a slight twisting motion will seat it down and
create an air-tight seal
Here
is a typical residential floor register:
click
on image to enlarge
Here
is the register duct kit installed:
click
on image to enlarge
Here
is the quick-connect hose installed on the register duct
kit:
click
on image to enlarge
|
